In the daily use of fluoroplastic centrifugal pumps, bearing fever is one of the frequently encountered failures, then when faced with such a failure, the reason is where? And how should we deal with? If everyone Interested in these issues, the following is about Fluoroplastic centrifugal pump bearing fever and treatment methods introduced. Fluoroplastic centrifugal pump bearing fever and treatment methods (1) bearing pad scraping unqualified. Approach is to repair bearing pads or replacement. (2) bearing clearance is too small. Approach is to re-adjust the bearing clearance or scraping. (3) Lack of oil, poor oil quality. Approach is to increase the oil or replace the oil. (4) bearing assembly bad. Approach is to check the bearing assembly requirements, eliminating unmet requirements. (5) cooling water circuit. Approach is to check and repair. (6) bearing wear or loose. Approach is to repair the bearing or scrapped. If the pine association, compound the relevant bolts. (7) shaft bending. The treatment method is to correct the pump shaft. (8) rejection oil ring deformation, rejection oil ring can not rotate, with no oil. Approach is to update the oil slinger. (9) Coupling misalignment or axial clearance is too small. Approach is to check the alignment and adjust the axial clearance. Read more: China Building Water Exhibition Pump Valve Tube Fittings Exhibition Water Expo Xiamen Maritime Exhibition Internet + Forum Yiwu Expo Industry Interconnection (Xiamen) Technology Co., Ltd. Asia Pump Network Editor: He Duanhui (QQ / WeChat: 2355962924) http://beng.liuti.cn/ (service hotline: 400-6030-811)
