As the saying goes, Baimi is a sparse. After the acceptance of the tile paving, the problem could not be detected. After a few years, there were often cases where the tiles were empty or even falling off. No matter what, the unsatisfactory on the ground, watching the polished tiles on the side, the empty glazed over there, many owners have a headache. I thought that this is a difficult time to buy online ceramic tiles, and I can safely live in a new home. I have not thought of it for a few years, and there are problems with the quality of tile paving.
Some people may propose to reinvent the original and simply put a new batch of tiles on the house, but obviously people will not do that. So, is there any good way to save the tiles that have already had problems?
There are two cases of falling off tiles. One is a large area, and the other is a small area of ​​partial shedding, and the treatment of different situations is not the same. After buying tiles and tiles, such as polished tiles, when large-area tiles are lifted or emptied, it is necessary to remove the tiles from the original raised or empty areas, remove the original cement mortar layer, and clean the base layer. Reapply the cement mortar. Be careful when cleaning polished tiles, don't break them, and if you can't use them again, you should buy new tiles.
Special attention should be paid to the re-pasting of the bathroom, the waterproof layer should be repainted, and the 24-hour water-tight test should be carried out. After the test is passed, the cement mortar and the tile should be applied, and care should be taken not to damage the original buried in the wall. Hydropower line.
Many owners asked, what should be done when there are only a few tiles in the house? If the mortar used for paving is not loose, only the tiles are detached, then the mortar attached to the back of the tile and the surrounding mortar can be scraped first. Add a small amount of cement into the paste in the 107 glue, evenly apply a thin layer on the back of the tile, and then press the tile to stick it. This is simple and easy, and avoids the dust flying when mixing cement mortar at home, polluting the indoor environment.
If the tile falls off, the cement mortar layer under the tile and the wall base layer or the ground base layer also loosen and “delayâ€, then the cement mortar layer can be cleaned with a blade and other tools, and the cement mortar is reapplied and the tile is laid. It should be noted that if the tile is only partially peeled off, it is not possible to tap the mortar on the base surface to prevent the original tile from being loose. When buying tiles, you may want to prepare some extra tiles for future needs. This saves extra money when replenishing and minimizes chromatic aberration.
Led Holiday Light,Outdoor Christmas Lights,Christmas Tree Lights,Led Christmas Lights
Yuyao Flylit Appliance Co.,Ltd , https://www.flylitlight.com