Carpentry acceptance points
1, gap
The wood sealing line, corner line, waistline veneer meet the mouth seam not exceeding 0.2mm, the line and the line mouth slot joint does not exceed 0.3mm, the veneer panel and the plate contact mouth does not exceed 0.2mm, the sliding surface door entire surface error does not exceed 0.3mm .
2, the structure
Check if the structure is straight. Whether horizontal or vertical, the correct carpentry practices should be straight.
3, corner
See if the corner is accurate. The normal corners are all 90 degrees, except for special design factors.
4, parquet
See if the spell is tight and accurate. The correct wooden pattern is to be seamless or to maintain a uniform distance.
5, modeling
Check if the arc and roundness are smooth and sleek. In addition to a single, a number of the same shape to ensure consistency in the shape. It should ensure that the surface of the woodworking project is flat and there is no drum or breakage. Symmetrical carpentry projects should be symmetrical.
6, cabinet door
Try to see if the cabinet door switch is normal. When the door is open, it should be light and no noise.
7, nail eyes
The nails used in the suspended ceiling structure need to be coated with rust paint on the nail eyes.
8, smooth
It should ensure that the surface of the woodworking project is flat and there is no drum or breakage.
9, symmetrical
Symmetric woodwork items are symmetrical.
Woodworking acceptance criteria
1. Whether there is a broken phenomenon in the woodwork project. It should ensure that the surface of the decoration of the woodworking project is flat and there is no drum or breakage.
2. Whether the decoration corner is accurate or not. The normal corners are 90 degrees, with the exception of special decoration design factors.
3. Whether the decoration decoration is strict and accurate. The correct decorative wooden parquet should be seamless or maintain a uniform distance.
4. Whether the arc and roundness of decoration are smooth and sleek. In addition to a single, a number of the same decorative decoration also ensure that the same shape.
5, cabinet door switch is normal. When the door is open, it should be light and no noise.
6, the fixed cabinet wall should generally have no gaps.
7, whether the decorative decoration structure is straight. Regardless of horizontal or vertical orientation, proper woodworking practices should be straightforward.
8. Symmetrical decoration woodwork items are symmetrical.
9, decorative panel nails have no make up. Of course, this is the painter's job, but because of its presence in the woodworking project, it is mentioned here.
10. Whether the corners of the ceiling line of the decorative ceiling decoration are smooth and there are no obvious lines or deformations.
11. Whether the skirt line is installed straight after installation and is accurate on the ground.
12. After the decoration, the ceilings of the toilets and kitchens, such as the aluminum buckle plate and the PVC buckle plate, are flat and have no deformation.
13. After the decoration, the installation position of the door handle lock is correct and normal.
14, after the decoration of the bedroom door and other doors open is normal. When closed, the upper, left and right door joints should be tight, and the lower door gap should be moderate, generally 0.5 cm.
Carpentry Acceptance Decoration Carpentry Knowledge Confucius Decoration Decoration Switch Paint Decoration Bedroom Door Kitchen Sliding Door Kitchen Doors Bedroom Doors Bedroom Doors
Oriented Particle Board(OSB)
Oriented Particle Board(OSB),Oriented Strand Board (OSB),Oriented Strand Board Vs Particle Board,OSB Particle Board
Linyi Fengzhize Trading Co., Ltd. , https://www.fengzhize.com