| Home>Bearing knowledge>Adjustment of bearing axial clearance |
Adjustment of bearing axial clearance
| /*250*250 was created on 2017/12/25*/ var cpro_id = 'u3171089'; |
1 Adjust the gasket method:
A set of soft material (soft steel sheet or elastic paper) gasket is placed between the bearing end cover and the end surface of the bearing housing. When adjusting, do not put the gasket on the bearing end cover; and evenly tighten the bearing end cover on one side. Screw; rotate the shaft by hand; until the bearing tumbler and the outer ring touch and there is no gap in the shaft to stop, then measure the gap between the bearing end cap and the end face of the bearing; plus the shaft required for the bearing in normal operation To the gap, this is the total thickness of the required gasket; then fill the prepared gasket between the bearing end cap and the end of the housing; finally tighten the screw.
2 Adjust the bolt method:
Press the pressure ring on the outer ring of the bearing; pressurize with the adjusting bolt before the pressure adjustment; first measure the pitch of the adjusting bolt; then gradually tighten the adjusting bolt; until there is no gap inside the bearing to stop; then calculate the adjusting bolt Corresponding rotation angle. For example, the pitch is 1.5 mm; the clearance required for the normal operation of the bearing; then the required rotation angle of the adjustment bolt is 3600×0. 15/l. 5=360, then turn the adjustment bolt 360; the bearing will get 0. 5mm axial clearance; then use the stop washer to fix it.
Recommend to friends comments close window
| Bearing related knowledge |
| Bearing selection and use criteria Aviation, aircraft and helicopter bearing applications Industrial bearings protection, overhaul, smooth, device bearing failure analysis method Transmission one-axis rear bearing damage view troubleshooting |
This article links to http://
Please indicate the bearing network http://
Previous: NSK bearing oscillation and temperature discrimination bearing damage Next: Fan bearing separation
Rhein Lighting has provided a line of ETL listed Led Panel Light. The flat panel light has No LGP, back-lit design, and the lens is made of PMMA and will not yellowing over time, which is much more bright and more durable than edge-lit light panel. Take 2x2 led light drop ceiling for example, it can replace the equivalent of 420W fluorescent tubes, saving you up to 80% in energy consumption.
The led ceiling panel light provides long-life and uniform illumination, in addition to being equipped with a 0-10V dimmable driver. These led light panels are ETL, DLC, CE, ROHS approved, and it has a 5 years limited warranty.
Rhein Lighting is a specialized in the design and manufacture of led panel downlight, led slim down light, backlit led panel light, led rope light, Led Strip Light, led plant light and Led Grow Light etc.
Ceiling Light Panel,Led Backlight Panel,Solar Panel String Lights,Raleno Led Video Light
Rhein Lighting Technology Co.,Ltd. , https://www.rheinlighting.com