After living in houses for many years, there are often phenomena such as shedding, yellowing and bubbles on the walls. These phenomena not only affect the overall appearance of the house, but also cause problems for the entire wall. Therefore, the walls must be refurbished. Then, what are the steps for the renovation of the old wall ? The following small editors will introduce them to you.
Old refurbished do-it-yourself steps
1, the old wall renovation yourself first wet the wall with water, so when the wall is removed more effort, the wall must be shoveled to expose the cement mortar surface. Then brush the interface agent. Be sure to brush it all evenly. Wall cracks are usually covered with kraft paper tape and white latex, but there is no guarantee that it will not crack.
2. If the wall is uneven, then you need to use plaster to level it. The error should not exceed 0.5 cm. Non-load-bearing walls generally need to be patched, so it is best to choose a good texture wall coverings and white latex, if conditions can be used mesh cloth, cracking will be better.
3, in the selection of putty should choose high grain fineness and texture harder, or add white latex to the putty to improve the hardness of putty. Fine sandpaper is used to sand the wall. If the sandpaper is too thick, it will leave a deep sand mark on the wall. Even if it is painted, there is no way to cover it. After the wall is polished, it must be cleaned again, otherwise too much dust will affect the paint adhesion.
4. When brushing the primer on the wall, be sure to brush every place and evenly. Brush the primer to use a good texture roller, so as not to affect the effect of paint brushing. After the putty is polished, some ugly pitholes are left on the wall, especially after painting, so you need to find a supplement. When you are looking for a make-up, be sure to polish the surface. In order to avoid color pitting, add more water to the primer and apply it again.
5, the best choice for the use of tools, such as the drum of the hair do not choose too short, but the hair should be fine, so that the paint out of the paint film more delicate feeling. The corners are usually treated with a stylus or a scrub brush, but this can cause corner textures and the entire surface to be inconsistent, so try to use an edge roller to handle the corners.
6, after the general latex paint can be dry in four hours, but the hardness of the paint film is not enough, so within seven to ten days do not use a cloth scrub or any contact with the wall.
Article Summary: The above is related to the introduction of the old wall renovation do-it-yourself , I hope you need help with the renovation of the wall. Here to remind everyone that in the transformation of space, we must know that bearing walls are absolutely not removable, and some non-load-bearing walls can not be demolished, otherwise it will have a serious impact.
Aluminum Led Wall Lamp,Wall Lights,Bathroom Wall Lights,Led Wall Lights
Jiangmen hengshenghui Lighting Co., Ltd , https://www.jmsunbright.com