Phenomenon 1: Wall Decorative Paint
Latex paint is the most common wall decoration material. It can be painted, rolled or sprayed during construction. If the workers are not serious or perfunctory during construction, small color differences often occur. Especially the darker emulsion paint, this problem will occur even more.
Warmth Tip: Latex paint needs to be filled with some water before use, deployment of good latex paint to be used up once. Paints of the same color are also best painted once. If the wall needs to be repaired after construction, the whole wall should be repainted again.
Phenomenon 2: Sewer line
When carrying out renovations, the construction team sometimes pours construction waste containing large amounts of cement, sand, and concrete into the sewers to save time. The direct consequence of this is a serious blockage of the sewer, causing the kitchen and toilet to run out of water due to poor water. Although some projects have no problems in the final acceptance, they always have problems with poor water.
Warmth Tip: Strictly supervise the construction team and cannot use the sewer as garbage roads. After the construction of the waterway is completed, all the basins, basins and bathtubs are filled with water, and then the water is discharged at the same time to see if the water is unobstructed and if there is any leakage of the pipeline.
Phenomenon 3: Wire Connector
When installing electric sockets, switches and lamps, electricians do not wire according to construction requirements. In particular, when consumers use some electric appliances such as water heaters and air conditioners that consume large amounts of electricity, the switches and outlets are heated and even burned, which brings great economic losses to consumers.
Warmth Tip: In the construction supervision of the electrician in strict accordance with the operating procedures for construction, after all the switches, sockets installed after the actual use must be to see whether these parts have a fever phenomenon.
Phenomenon 4: Wall tiles
Paving tiles are a highly technical process. If workers cut corners, they are most prone to problems such as hollowing of tiles and misalignment. In addition, cement and adhesives used for paving ceramic tiles are also delicate. If the mix ratio is unreasonable, there will be problems such as falling off.
Warmth Tip: According to the Beijing Municipal Construction Committee promulgated the "family home decoration project quality acceptance standards", requires that the tile wall tile should be smooth and solid, clear patterns, no dirt and slurry marks, the surface color is basically the same, uniform seams, plate crack-free , Drop angles and missing edges, local emptying may not exceed 5% of the total.
Phenomenon 5: Wall ticking
The buried pipeline must be slotted on the wall and ground in order to bury the pipeline. A few workers perform barbaric construction during the grooving operation, which not only damages the building load-bearing structure, but also may cause damage to other nearby pipelines.
Warmth Tip: Prior to construction, it is necessary to reconfirm the direction and location of the pipeline with the construction team leader. The requirements for slotting are different for different wall structures. The wall in the house is not allowed to be slotted, and the wall with insulation after the slotting, it is easy to cause cracking on the surface, and in the ground slot, we must be careful not to damage the floor, to the residents downstairs Create trouble.