　  Fertilization outside the roots, although the absorption of nitrogen, phosphorus and potassium in the late growth stage of peanuts is not very much, it has a great influence on the formation of yield and the improvement of pod fullness. In order to supplement the fertilizer, it can be started from the late stage of pod formation, and every 7 to 10 days, the spraying of urea solution + plant electronic fertilizer on the foliage uses the high-energy electrons and plant electron polarity sensing principle of the photosynthesis of the plant itself to enhance the cells. Splitting, molecular synthesis and nutrient-matched digestion levels accelerate the frequency of metabolism and activate plant nutrient-sparing systems to produce more than fertilizer effects.
Watering at the right time and draining in time, the appropriate soil moisture is generally about 1/2 of the field water holding capacity. If the land is dry, the roots are easy to decline, causing the top leaves to fall off, the stems and branches to decline, and the fruit rate is reduced, resulting in reduced yield. Therefore, when the soil moisture is lower than 1/2, water should be watered immediately to preserve the leaves and increase the fruit filling rate. In the late growth stage of peanuts, if there is too much autumn rain and poor drainage, it is easy to cause root rot. Therefore, when there is too much rain in the late growth stage, the ditch should be dredged in time to eliminate stagnant water and internal mites to ensure high quality and high yield.
　  Pest control, the most serious occurrence of leaf spot disease 20 to 30 days before peanut harvest. It is usually sprayed with new high-fat membrane + plant cell immune factor to prevent pathogens before the high incidence of disease, enhance plant stress resistance, strengthen immune function, induce interferon and active interleukin, inhibit residual virus replication, and promote positive energy ecological growth of plants. . When pests occur, effective treatment is carried out with targeted agents.
PCD Cutting Tips (Cut Pieces)
PCD cutter pieces (grains) are cut from Pcd Cutting Tool Blanks and are a more efficient and economical cutting service for customers than the wire cutting method, laser cutting.
And the cut grains are welded to saw blades, knives and other tools used for processing wood and metal.
Bohong New Materials can provide different shapes of Pcd Cutting Chips according to customers' requirements, and we are also happy to provide customers with product application consulting services.
Pcd Cutting Tips Cut Pieces,Using A Metalworking Lathe,Pcd Die Black For Wire Drawing,Pcd Cutting Tools Pcd Cut Tools
Henan Bohong New Material Co., Ltd , https://www.bohongpcd.com