(2) The above program expresses the holes of the first group. As for the holes of the second group, the above procedure can be completely taken, but only a few parameters can be modified. See the following procedure:
Group 1 hole
(3) If the angle is given first (usually divisible by 360°), the program does not need to make major changes, only the previous parameters and their order are modified appropriately, where aperture #3 does not need to be given, but parameter # The value of 7 must consider the influence of the actual aperture #3 and the inner diameter of the cylinder #1 to avoid interference between adjacent holes, as follows:
Given the linear hole spacing in the X direction
(4) As mentioned above, the program O0550 itself contains some derivation formulas for the associated parameters, and therefore has very good adaptive capabilities.
For more articles, please refer to "Metal Processing" Cold Processing 2008 No. 1
Previous page
LED Sensor Batten Lights has options of microwave sensor and infrared sensor. There are two sensing modes. One is 0-10v dimming, and the other is on/off.
The main difference between these two modes is that the 0-10v dimming mode can set the brightness of the light after the person walks, and the pending time of this brightness can also be set. On/off mode, you can only set the time for the lights to turn off after a person walks, but not the brightness (that is, functions 3, 4 cannot be implemented). The 0-10v dimming mode is more intelligent.
Briefly introduce the function of sensor light:
1. Set up daylight threshold: If the ambient light is higher than the set brightness, the sensing function will not be triggered.
2. Set up the hold time: The time for the light to maintain brightness after the person walks away.
3. Set up a stand-by dim level: set the brightness maintained after the person walks
4. Set up stand-by time: After the person walks, the time to maintain low brightness
5. Set up detection area: Set the detection area.
Toggle button can set the remote distance of remote control and sensor.
If you need sensor lights in factories or warehouses, corridors, or other indoors, you can choose this LED Sensor batten lights. If you need IP66 sensor light, you can choose Sensor Waterproof Light.
Motion Sensor Led Light,Sensor Led Light,Motion Sensor with Led Light,Led Light Motion Sensor
SHENZHEN LITEHOME OPTOELECTRONIC TECHNOLOGY CO., LTD. , https://www.szlitehomelight.com